Search:

I have a 2021 300 Verado, I am hearing a beeping sounds every 30 seconds, someone said it’s because my battery’s are dead? How do I stop the beeping until I replace my battery’s? This is while it’s...

2021 Dvx20 300 Verado, key pad dead and 30 second beep even when battery’s are disconnected. Thinking my main battery’s are dead. How do I stop the beeping sound every 30 seconds?

What cc amps should be my minimum?

I have turbo seal hubs by tie down. Not vortex. Still have play if you take wheel and move up and down. Just not sure how much is acceptable. Will call Tie Down Monday

Does anyone know how much play the wheel hubs should have “vortex” non maintenance ones? I have minimal movement when I have trailer jacked up, no grease on back side of wheels, just do not want to...

Thanks,remember last year, guessing same.

Can I take 75 to 96 to 94 to 23 mile rd exit. Or what would be better a Monday morning? Com8ng from Toledo area. Ay help would be great.

Have a 2008 Ranger z520 with a 250 pro Xs, without starting in garage,the shifter moves very hard in forward and reverse, like cables sticking, had to run a cable through the wire harness hole in...

Got it, PIA!! Ran separate cable and thanks to all for the help the harbor freight cable fish tape was the deal, now to tackle the LSS2 cable from stern to console now. Hope it’s jot as bad.

I have no access cover anywhere under console.by wires that come through. Do I need to take off cover that is around my shifter?

back by the steering console, the hole the wires are is that where the tubing comes from the front, I can't see it at all.

Having issues pulling old e-cable from bow of my 2008 Z520 to get new cable to console. Won’t budge.dont want to break anything.what am I missing? Thought I could just attach new cable to old one and...

Start with 0 and move up from there. I needed 0 in mine.

Not sure where I need to mount the LSS2 on bottom of my Z520. 2008. Pictures would help. Getting a HDs12 gen 3.at Russell Marine.

Just wondering witch ramps would be good to launch at St. Clair fishing the Mile run, will be by myself for a few days. I was there first week of May last year and had issues end of week getting...

thanks

thanks will give it a try

Anyone have any Ideas on how many of the 8 holes I would need to plug for a Pro Xs 250 on a 21 foot Ranger Z520C? I was told to start with 3? not too sure. Any help would be great!

Rothwell marine AR.

got it thanks!!

Got both screws off back of seat, but can't figure out what else I need to do to get seat out, seams like it is in with other screws I can't see.

ok, thanks,what would you suggest I get for my 2008 250 pro xs in a 4 blade?

I have a chance to buy a Trophy 4 blade part #48-825912A45 FOR MY 2008 250 PRO XS. not sure if it will work. does anyone know if it would be the correct one?

Auto zone, stay with the originals and gap at what it says on front of engine tag.

Thanks!:thumb up2: