Updated Live/AT2 software--and now no sonar

[squib]

Hi. Updated my headunit and AT2 module last week. Fished a tournament yesterday, and could not get the sonar view to work nor could I get a depth reading on my Active Target view. Switched sonar channels off an on in setup and nothing had an impact. Any pointer on where I can start today on getting it back to working?

[kennybryan]

Try PAGES, SETTINGS, SONAR, AUTO CONFIGURE

[webdude]

Good morning! Were you able to resolve your issue? Thanks!

[mikeky]

Did your ranges change beyond the depth of water you are fishing?

[squib]

Not sure if it is working or not. Have not been back to the lake. On my FFS, I just want the depth to display as an overlay. Worked forever. Not it is just two dashes --

[Basshopper]

Check the source for depth. Remember if you stop sonar on all transducers other than AT set the source for depth to the AT then it has an element for depth built in and will not interfere with AT.

[Team Colibri]

Restore sonar-defaults and set it up again.