Results 1 to 7 of 7
  1. #1
    Member 78Staff's Avatar
    Join Date
    Mar 2012
    Location
    Cosmo, FL
    Posts
    5,277

    Skeeter Parts Pay it Forward...

    So, in a bit of a "pay it forward" theme, I've got a couple skeeter items I don't need anymore, and will send to first to PM me that they want it... Just cover shipping cost for either (or both if you need them) and they are yours...

    (Gone) 91202679 - Trim Piece for Glove Box opening. This is the trim part for the glove box opening. Useful if you are trying to to do the FX Carpeted Lid swap or if you just need a replacement for an old or cracked one. Prob $10 or less for shipping.

    And if you watch Brandon Palinuk's Skeeter videos, you are familiar with his (and others probably too) trick of adding top bulb weatherstriping to the lockers to help with keeping water out... well I tried it and I just don't care for how the lids don't lay completely flat after install them, so pulled them off pretty quick. I've cut the front deck compartments and the two rear, and still have some left uncut as well. You get it all, the pre-cuts for rod and center lockers and the remaining uncut roll - again just cover shipping. It's all a bit heavy, I figure $20 max for shipping.


    Last edited by 78Staff; 06-10-2024 at 06:27 PM.

  2. Member 78Staff's Avatar
    Join Date
    Mar 2012
    Location
    Cosmo, FL
    Posts
    5,277
    #2
    bump for the trim if anyone wants it before it gets pitched in the recycle bin...

  3. Member
    Join Date
    Feb 2014
    Location
    Louisiana
    Posts
    623
    #3
    Good job 78! Always good to see a "pay it forward!"

  4. Member
    Join Date
    Jul 2012
    Location
    Houston
    Posts
    440
    #4
    I've got the box trim and lid from a 2017 ZX250

  5. Member
    Join Date
    Aug 2014
    Location
    West Palm Beach, FL.
    Posts
    503
    #5
    Does your guys trim molding have metal in it ?

  6. Member
    Join Date
    Aug 2014
    Location
    West Palm Beach, FL.
    Posts
    503
    #6
    Never mind

  7. Member 78Staff's Avatar
    Join Date
    Mar 2012
    Location
    Cosmo, FL
    Posts
    5,277
    #7
    Quote Originally Posted by k3fishing View Post
    Does your guys trim molding have metal in it ?
    It doea have metal in the lower section that goes over the lip...