I have a 2017 Ranger 520c. I noticed that tires are not wearing evenly. All four tires are showing a lot more wear on the inside edge. Is there a way I can correct it before putting new tires on it? I believe I seen a post on here probably a year ago about replacing the torsion are bolts to help correct this. Appreciate any help.
New torsion bolts from Basscat and tighten to the proper Torque is where I would start at
2022 z519 cup 225 merc 4s ser # 3B210484. 2--hds12 live units. 2 poles, atlas plate, ghost, hamby's, active target, merc digital gauges
2002 basscat pantera 3 (dad bought new) sold 8-2-22
2000 stratos 20 ss (bought new) 200 hp Rude ficht great boat/motor sold 11-21
pulled by a 2500HD Denali
proud dad of an ARMY Captain
MAGA
ASE/GM Master tech before tools
I had 2 on my 2014 that wore on the inside on opposite corners on a 2 axle. I pulled the tires off and found that the arm of the torsion bar where the splined hub comes thru, the spline was not flush with the arm. I removed the bolt, tapped the spline flush, replaced the bolt with those from BBC, torqued to 150 foot pounds and now all is good !!
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Vatrer Lithium / V-T2 Vents
Thanks guys, I believe that’s where I’ll start.
https://basscatstore.com/torsion-2-bolt-kit201711.htmlOriginally Posted by allenneal
2022 z519 cup 225 merc 4s ser # 3B210484. 2--hds12 live units. 2 poles, atlas plate, ghost, hamby's, active target, merc digital gauges
2002 basscat pantera 3 (dad bought new) sold 8-2-22
2000 stratos 20 ss (bought new) 200 hp Rude ficht great boat/motor sold 11-21
pulled by a 2500HD Denali
proud dad of an ARMY Captain
MAGA
ASE/GM Master tech before tools
Reply With Quote