Good Afternoon,
I have a 2014 Yamaha VF 200 SHO. In the attached picture is the location of a bolt that I believe holds a ground wire. The head of the bolt sheared off and the wire became loose. I am hoping someone with the same engine can tell me what size/thread the bolt is, the type of head and the length. I can tell you it is bigger than a #10 and also larger than an M5 (I'm not sure if it's standard are metric) It is also smaller than 1/4".
Thank you for the help..
Scott in Louisiana
In Search of Big Bass (ok, any Bass)!!
2015 Ranger Z119C, Yamaha 200 SHO
Definitely metric.
Not a bolt. A grease nipple.
Thank you so much. That's why I couldn't find a bolt to fit the hole. Used an drill and extractor to remove it, but thought it was awfully short.
UPDATE: Just in case someone else runs into this problem, it is a 6MM Grease Zerk that you can get at Auto parts store. See the picture below.
Thank you again
Last edited by sclahasky; 09-23-2024 at 11:07 AM.
Scott in Louisiana
In Search of Big Bass (ok, any Bass)!!
2015 Ranger Z119C, Yamaha 200 SHO
How did it get sheared off?
The transom saver I have (like the picture below) was put on too tight. My buddy was trying to help and he put the PVC part up too high and that sheared it off.
Last edited by sclahasky; 09-23-2024 at 12:15 PM.
Scott in Louisiana
In Search of Big Bass (ok, any Bass)!!
2015 Ranger Z119C, Yamaha 200 SHO
Not the first sheared fitting. Won't be the last.
It’s the first one in 10 years so I guess I’m doing good
Scott in Louisiana
In Search of Big Bass (ok, any Bass)!!
2015 Ranger Z119C, Yamaha 200 SHO
Reply With Quote