Bow setup opinions

[chad202]

My current setup is a solix 10 gen1 that’s networked to solix 15” at the console. At the bow I have the external trolling motor transducer that does SI/DI/2D. I also have built in transducer inside the troller. I want to add mega 360 so my plan is to remove the external transducer since I’d be using mega 360 99% of the time. If I want 2D I could use the one in the troller on my existing solix but it’ll be used mainly for mapping. Thinking adding a solix 12 or apex13 for the mega 360. Do I need to network it all? How would you set this up?

[AndrewM-Fishing]

I'd put the 15 on the bow for the M360 with the 10 up there for mapping/2d/di (assuming the 15 is a g2). Put the new 12g3 on the console, less lag with the mapping.

[SLYDoggie]

I'd put the 15 on the bow for the M360 with the 10 up there for mapping/2d/di (assuming the 15 is a g2). Put the new 12g3 on the console, less lag with the mapping.

I second this!

[chad202]

The 15” at the console is also a Gen1 so the new one would have to be at the bow for the 360.